What to Photograph Before the Engineer Arrives: A Simple Guide for Householders

What to Photograph Before the Engineer Arrives: A Simple Guide for Householders

When something goes wrong at home, a few clear photos taken on your phone can save a lot of back-and-forth. They help an engineer understand the problem before they set off, bring the right parts, and they give your insurer, landlord or boiler manufacturer a record of what happened and when. You don’t need to be technical. You just need to know what’s worth capturing, and when to put the phone away.

The golden rule: make the situation safe first, then take pictures only from a dry, safe spot. No photo is worth getting close to escaping gas, live electrics or dirty floodwater.

Before you take a single picture

  1. If you smell gas or a carbon monoxide alarm goes off, don’t take photos at all. Leave straight away and follow the gas emergency steps further down this page.
  2. If water is leaking, turn off the inside stopcock first. Not sure where it is? Our guide on how to find and turn off your stopcock will help.
  3. Keep out of rooms where water has reached sockets, lights or the fuse box. Photograph from the doorway, or not at all. See our advice on a water leak near electrics.
  4. Don’t stand under a bulging or sagging ceiling. Take the picture from outside the room. Our water through the ceiling guide explains why.
  5. Don’t wade into floodwater. It may be contaminated or touching electrics you can’t see.

If the boiler or heating has stopped

These shots help a Gas Safe engineer narrow down the fault before they arrive. Only photograph the outside of the boiler, exactly as you see it day to day.

  1. The display or warning lights. Snap the fault code or flashing light clearly, and note the time it appeared. Our boiler fault code guide explains what the common codes mean for you.
  2. The pressure gauge. A close photo of the needle or digital reading shows whether pressure has dropped. If it’s low, our low boiler pressure guide covers what you’re allowed to do using the filling loop, as the manual describes.
  3. The data badge or model label. Many boilers show the make and model on the front or underneath. Photograph it only where you can see it without opening anything.
  4. The timer, programmer and room thermostat settings. These rule out simple setting problems. If the heating simply won’t start, try our heating won’t come on checks.
  5. Any water dripping from underneath, taken from a step back, without touching pipes or valves.
  6. The last service record or the page of the boiler manual you followed, if you have it to hand.

Under the Gas Safety (Installation and Use) Regulations 1998, only a Gas Safe registered engineer may work on gas pipework and gas appliances. So don’t take the casing off to get a better shot, don’t touch the gas valve, burner or flue, and don’t try to relight the boiler beyond what the user manual says. If it keeps locking out or losing pressure after a single reset, that’s a job for a Gas Safe engineer.

If there’s a leak

  1. A wide shot of the area so we can see which room, and where the leak sits in it.
  2. A close-up of where the water seems to be coming from, such as a joint under the sink, a radiator valve or a ceiling stain. For radiators, see our radiator leaking guide.
  3. The stopcock in its closed position, so there’s a record that the water was turned off and when.
  4. The water meter reading if you have one, both before and a little while after turning the water off. Our water meter leak guide shows how to use it.
  5. Any damage to floors, walls, ceilings, furniture and carpets, before you start mopping up. The Association of British Insurers advises not rushing to throw damaged items away, as your insurer may want to see them, and to photograph anything you do have to remove.
  6. A short video can be helpful if a drip comes and goes, or if a pipe makes a noise only when a tap runs.

If the leak is in the garden, the pavement or the road, the outside or boundary stop tap usually belongs to your water company. It may need a special key, so don’t dig it up or force it. Check whether neighbours have lost water or pressure too, then contact Anglian Water or Essex & Suffolk Water about a leak on their side. A photo of the wet patch or bubbling water from the pavement is useful for them. More in our outside stop tap guide.

Please don’t make temporary fixes to the supply pipework with tape or filler. Any repair to the water supply must meet the Water Supply (Water Fittings) Regulations 1999, so it’s best left to a qualified plumber.

If the electrics have tripped

  1. Photograph the consumer unit (fuse box) with its cover closed, so the switch positions are visible. This shows which RCD or circuit breaker has gone off.
  2. Note what was switched on when it tripped: a kettle, a shower, an outside light.
  3. With dry hands and a dry floor, you can reset a tripped RCD or breaker once. If it trips again, leave it off. Our RCD tripped guide explains more.
  4. Any scorch marks, burning smells or melted plugs should be photographed from a distance and never touched.

Never touch electrics near water. Fault finding and wiring work must be done by a registered electrician under Part P of the Building Regulations. Electrical Safety First also advises photographing flood damage and keeping records for your insurer, and using a registered electrician before anything is switched back on.

Tips for useful photos

  • Turn on the room light (only if the switch is dry and away from the leak) or use your phone’s torch.
  • Take one wide picture and one close-up of each problem.
  • Keep the date and time stamp on, or write down when each photo was taken.
  • Put something familiar in the frame, like a coin or a tape measure, to show the size of a stain or crack.
  • Save the photos into one album and keep any receipts for emergency costs.
  • Send them to us by WhatsApp when you get in touch, so the engineer can see them before arriving.

Who else might need the photos

  • Your home insurer. Most have a 24-hour claims line. Call them early for advice before arranging non-urgent repairs.
  • Your landlord or letting agent if you rent. Citizens Advice says that if you rent, your landlord is responsible for repairing or replacing a broken boiler, and you shouldn’t try to fix it yourself. Our guide for renters with no heating or hot water has more.
  • The boiler manufacturer if the boiler is still under warranty. They may ask for the model details and fault code.
  • Your water company if the problem looks like it’s on their side of the boundary.

If you smell gas or suspect carbon monoxide

Put the phone in your pocket and get out. Leave the property, opening doors and windows on the way if it’s safe to do so. Don’t use light switches, electrical switches or naked flames. Turn the gas off at the meter only if it’s safe, then call the National Gas Emergency Service on 0800 111 999. If anyone has headaches, dizziness, sickness, breathlessness or collapses, get medical advice straight away. Read our guides on what to do if you smell gas and the signs of carbon monoxide. You can check that any engineer is registered on the Gas Safe Register.

A charged phone is also part of a good winter home emergency kit, so you can take photos and call for help even during a power cut.

When to stop and call us

  • Water keeps flowing after you’ve closed the stopcock, or the stopcock won’t move.
  • Water has reached sockets, lights or the consumer unit.
  • A ceiling is bulging, sagging or dripping heavily.
  • The boiler keeps locking out, keeps losing pressure or shows a code the manual says needs an engineer.
  • An RCD or breaker trips again after one reset, or you notice scorching or a burning smell.
  • You can’t safely see the problem to photograph it. That’s fine: just tell us what you’ve noticed.

We provide emergency plumbing, boiler repairs and domestic electrical work for homes across our local area. If you’re dealing with a burst pipe right now, start with our flood or burst pipe guide.

Send us your photos and we’ll come out

Call 01787 278511 or WhatsApp 07825 348536. With over 10 local engineers, we’ll attend as soon as possible, even at midnight.

Anglian PHE Ltd, Top Floor, 4 Market Hill, Clare, Sudbury CO10 8NN. Gas Safe 572792, NAPIT registered, trading since 1993, and no call-out fee.

Sources

This is general safety guidance. If you’re unsure, stop and call a qualified engineer.

Similar Posts